Char-Griller LP Gas Grill Grillin Pro 3001 - Manual (Page 11)

page 11
Step 7
Attach the CATCH PAN to the underside of the GRILL BODY using two (2) ½” BOLTS as
shown. Make sure that the side of the catch pan with the label “Wheel Side” is on the side of
the grill with the wheels. From the rear of the grill, slide the GREASE TRAY into the
guides/rails under the CATCH PAN.
™ & © Char-Griller / A&J Mfg.
Note: the hose should
be on the outside of
the leg brace.
CORRECT
WRONG
X
Step 8
Install the SIDE BURNER and the CONTROL PANEL to the firebox. Attach with eight (8) ½”
BOLTS and eight (8) LOCK WASHERS. From inside the GAS GRILL BODY the BOLTS will
first go through the GRILL BODY and then screw into the SIDE BURNER and CONTROL
PANEL. See Figures below.
WRONG
HOSE
LOCATION
X
WRONG
Lock Washers
Bolts
Lock Washers
Bolts