Inovonics EN4232MR - Manual (Page 6)

© Inovonics, 2011 - www.inovonics.com 6
14 ADT Focus 200 Plus / Focus Cadet Control Panel Wiring and Programming Information
14.1 Typical EN4232MR Receiver Connection to ADT Focus 200 Plus / Focus Cadet Control Panel
EN4232MR Function EN4232MR
Terminal
Panel Terminal Keypad Text
Power in (12V DC) Vs (19) + Aux Power n/a
Ground GND (20) - Aux Power n/a
Alarm 1 NC (1) (25) Point 1 (user text)
(Follower) C (1) (26) Common
NO (1)
Alarm 2 NC (2) (27) Point 2 (user text)
(Follower) C (2) (28) Common
NO (2)
Repeater AC Loss NC (3) (29) Point 3 RF Repeater AC
(Follower) C (3) (30) Common
NO (3)
RF Pt Low Battery NC (4) (32) Point 4 RF Pt Low Batt
(Latching) C (4) (31) Common
NO (4)
RF Pt Tamper NC (5) RF Pt Trouble
(Latching) C (5) (34) Common
NO (5)* (33) Point 5
RF Pt Inactive NC(6) (35) Point 6 RF Pt Inactive
(Follower) C (6) (34) Common
NO (6)
Power Loss POWER LOSS (36) Point 7 RF Recvr Power
(Follower) (37) n/a
Receiver Tamper NO (TAMP) * n/a
(Follower) C (TAMP) * n/a
RF Jam NC (JAM) (38) Point 8 RF System Jammed
(Follower) C (JAM) (37) Common
* Point 5 is normally open to allow RF Pt Tamper and Receiver Tamper on one loop.
The 2K-ohm end-of-line resistor is connected across TAMP NO (normally open) and TAMP C (common)
Wire from TAMP NO to 5 NO.
Wire from TAMP C to 5 C.