Inovonics FA416 - Manual (Page 11)

© 1997 Inovonics Wireless Corporation LIT-FA416-INSTALL 11 02304e 23-Oct-02
Appendix A:
Default Receiver Parameters
Active on
Output Condition Programmable Options
1 Alarm Alarm / Alarm+Tamper / Disabled
2 Alarm Alarm / Alarm+Tamper / Disabled
3 Alarm Alarm / Alarm+Tamper / Disabled
4 Alarm Alarm / Alarm+Tamper / Disabled
Transmitter Default
Condition Mode
Alarm Follower Follower / Momentary / Latching
Inactive Follower Follower / Momentary / Latching
Tamper Latching Follower / Momentary / Latching
Low Batt Latching Follower / Momentary / Latching
Default Momentary Output time: 4 seconds 1 - 16 seconds
Default Receiver Parameters:
System ID: (randomly assigned at factory) 0 - 255
Point supervision: Yes Yes / No
Supervision window: 4 hours 1 - 99 minutes, 1 - 99 hours
Access code: 3446 0000 - 9999
Vision Plus compatible: No Yes / No (Refer to FA116 user manual)
Programmable Options may be modified only by using the FA116 Executive Programmer.
Appendix B:
Default Transmitter Parameters
Switch Output Check-in
Point Contact Channel Seconds
1* N/O 1 60
2* N/O 2 60
3* N/C 3 60
4* N/C 4 60
5 N/O 1 60
6 N/O 2 60
7 N/O 3 60
8 N/O 4 60
9 N/C 1 60
10 N/C 2 60
11 N/C 3 60
12 N/C 4 60
13 N/C 1 60
14 N/C 2 60
15 N/C 3 60
16 N/C 4 60
*Only points 1 through 4 can be programmed from the FA416 and FA416R. Points 1-16 may be programmed from the FA416D and
FA416DR. The FA116 programmer can be used to change any transmitter options on any receiver for all 16 points.
Note: Portable panic transmitters which may be taken off-site or out of range or should nonetheless be programmed to check in. After a
transmitter has been programmed, the receiver programming for that point should be changed (with an FA116) so that the transmitter will
not be declared inactive.