Jaclo Faucet, Lavatory Faucet - 5840-T634 User Manual
Page 3
jaclo
industries | 129 Dermody Street Cranford, NJ 07016
p 908.653.4433 | 800.852.3906 f 908.653.1717 | 800.852.4133
CREATED 8.6.2014
JACLO.COM | PG 3
FIGURE 5
HOT
COLD
Spout Installation
Note: Some items have been
pre-assembled at the factory to
ensure quality and fit. Some
disassembly may be required
during installation.
1. Remove long hex nut (13) and
washer (12) from spout mounting
nipple (14).
Figure 1.
2. Slide the spout assembly with the
hoses attached through the center
hole in the counter top or basin.
3. Slide washer (12) and thread long
hex nut (13) onto nipple (14) and
secure spout to counter top or basin
once positioned correctly.
Figure 2.
Valve Installation
1. Identify hot and cold valves. Hot
has red ring and cold has blue ring.
2. Install hot valve on left side of spout
when facing sink.
Figure 3
3. Install cold valve on right side of
spout when facing sink.
Figure 3.
4. Remove handle, escutcheon, and
top valve nut.
5. Adjust lower valve nut (9) down
away from valve stem.
Figure 4.
6. Place fiber washer (8) on top of nut.
7. Find handle/escutcheon "A"
dimension.
Figure 5.
8. Thread nut up towards stem so
distance from top of fiber washer to
top of valve stem= "A" dimension +
counter or basin thickness.
9. Install valve through bottom of
counter or basin.
Figure 4.
10. Install top nut and escutcheon on
to valve and tighten. Note: not all
handle escutcheon combinations
use a top nut.
Figure 5.
11. Confirm "A" dimension for faucet
model installed. Adjust if necessary.
Hose Installation
1. Connect hot hose to hot valve side
outlet.
Figure 3. Hot hose is factory
connected to hot hose fitting in
spout (15).
2. Connect cold hose to cold valve
side outlet.
Figure 3. Cold hose
is factory connected to cold hose
fitting (16) in spout.
3. Connect supply hoses or tubes
(not supplied) to base of hot and
cold valves.
Figure 4.
FIGURE 1
FIGURE 3
FIGURE 4
FIGURE 2
Valve Stem
Counter or
Basin