KEYENCE SJ-F100W/100/010 - Manual (Page 5)

iii
„ Installation Precautions
Avoid installing the SJ-F100W/100/010 in the following locations as this may cause accidents.
„ About Warming up the SJ-F100W/100/010
Leave the SJ-F100W/100/010 for about 20 minutes after turning the power ON to
allow the ion balance to stabilize.
The ion balance may be unstable during this warming up period.
„ Other Precautions
• Locations directly subject to vibration and shock
• Locations subject to ambient temperature out of the 0°C to +50°C range
• Locations subject to ambient humidity out of the 35 to 65%RH range
(condensation not allowed)
• Locations subject to sudden changes in temperature
• Locations subject directly from blasts from air conditioners
• Locations subject to voltatile or flammable substance, solvents or corrosive
gases
• Locations subject to large amounts of dirt, and dust, salt, iron and oil smoke
• Locations that may be splashed with water, oil or chemical mist
• Locations where strong magnetic and electrical fields are generated
CAUTION
Note
• Be sure to read the WARNINGS and CAUTIONS described in each of the items
in this Instruction Manual.
• The Static Elimination Blower Unit has a built-in EEPROM. Do not turn the
Static Elimination Blower Unit OFF during the setup.
Refer to the following diagram when installing the SJ-F100W/100/010.
• Install the Static Elimination Blower Unit away from the wall or surrounding
objects.
• Install the Static Elimination Blower Unit so that the Electrode Unit can be
removed for replacement.
CAUTION
CAUTION
30 mm or more
50 mm or more