Kimber Model 84M - Manual (Page 10)

B. Installing the Bolt
Your rifle is completely assembled except for the bolt, which has been
removed for safety during transportation and storage. The bolt is packed
separately in the shipping carton.
1. To install, hold rifle in your left hand.
2. With your right hand, slip the bolt head forward into the receiver.
NOTE: Special care should be taken not to contact the comb of the
stock as damage could occur.
3. Rotate the bolt handle down to place bolt in the fully closed position.
C. Removal of Bolt
1. Point rifle in safe direction.
2. Place the safety switch to the rear (on safe) position. Keep your finger
away from the trigger.
3. Lift the bolt handle and slide the bolt to the rear. Check the ejection port
to confirm that the firing chamber is empty.
4. Find the bolt stop lever (see Fig. C1), a small rectangular knob at the left
rear section of the receiver.
5. While pushing the bolt stop lever down, pull the bolt fully to the rear
and clear of the receiver. (see Fig. C2)
B1
Inserting Bolt - 84M
C1
Bolt stop
NOTE: Every time you lift the
bolt handle it automatically
blocks the firing pin so the rifle
cannot be fired. If the bolt is
closed the rifle will be ready to
fire unless you manually apply
the safety.
10