Kimber Model 84M - Manual (Page 11)

NOTE: Be careful not to contact the comb of the stock, as damage to the
finish may occur. This type of damage will not be covered under Warranty.
D. Loading and Firing the Rifle
1. Point the rifle in a safe position.
2. Before attempting to load the rifle it is imperative too visually inspect
that the barrel is clear of oil, dry and free of any obstructions.
3. Check that you have the proper caliber ammunition. (Check caliber of
rifle on the barrel where the barrel and receiver meet.)
4. Place the safety lever into Position 2 (see Fig. A2).
5. Raise the bolt handle and slide the bolt to the most rearward position.
6. Feeding one cartridge at a time, push three of the correct caliber
cartridges into the magazine, making sure to keep cartridge aligned with the
chamber (see Fig. D1 & D2).
7. To close the bolt, first, use your fingers to push the cartridges all the way
into the magazine. Then, while pushing the top cartridge downward with
your thumb or finger, enough to clear the bolt, slowly slide the bolt
assembly forward so that the bolt glides over the top of the cartridge in
the magazine.
8. When the bolt is fully seated, push the bolt handle down.
THE RIFLE IS NOW LOADED WITH AN EMPTY CHAMBER.
9. Lift the bolt handle, pull the bolt fully to the rear, slide bolt forward, picking
up the cartridge, when the bolt is fully closed, rotate bolt handle down,
pull the safety lever to the Position 3 (see Fig. A3).
THE RIFLE IS NOW LOADED!
10. To fire the rifle, push the safety to the forward position (see Fig. A1).
THE RIFLE IS NOW READY TO FIRE!
C2
Bolt removal
11