Kofax Release Script - Manual (Page 21)

Kofax Capture Release Script for FileNet Image Services Release Notes
Kofax, Inc. 17
Error 1904. Module < mapped drive > failed to register. HRESULT –2147467259. Contact
your support personnel.
Workaround: The error message is incorrect and can simply be ignored. Click the Ignore button
and the release script will successfully install and register the release script.
If you click the Abort button, the installation will end. If you click the Retry button, you will
receive the error message again.
Problems When Uninstalling the Release Script
If you click the Cancel button while you are uninstalling the release script, all the release script
original files will remain properly installed on the system. However, depending on the point
during the uninstallation that the Cancel button is clicked, the release script may be un-registered.
In such a case, once you attempt to log on to the release script, login will fail. (SPR 31221)
Workaround: If this problem occurs, run Repair.
Refer to Repairing the Release Script on page 13 for more information. Alternatively, you can re-
register the release script in the Release Script Manager.
SMALLINT Data Type Limitation
The Kofax Capture SMALLINT data type cannot be linked to a FileNet Image Services numeric
data type. If an Kofax Capture SMALLINT data type is linked to the FileNet Image Services
numeric field on the Document Settings tab, release setup will prompt the user with the following
error message. (SPR 25866)
Error Description: The following field types do not match:
Numeric-Double
SmallInt_5-Small Integer
Document Attribute Field Length Limitation
Release will fail without any errors if more than 164-characters are used for any document
attribute field. This is a limitation of the FileNet Image Services API. (FileNet Incident 10096459;
Kofax SPR 25869)
Upper ASCII Character Limitations When Creating Folders
Due to a limitation with FileNet Image Services, you cannot create a folder when the following
upper ASCII character appears after any other character. (SPR 00009846)
„
€ (ASCII 128)
„
µ (ASCII 181)
„
ß (ASCII 223)
„
Ÿ (ASCII 159)
„
ÿ (ASCII 255)
For example, if you attempt to create a folder with the name Louÿs, release will fail with the
following error message.