Kofax Export Connector 1.0.0 for Pega Rules Process Commander - Manual (Page 11)

Kofax Export Connector 1.0.0 for Pega Rules Process Commander Administrator's Guide 11
Chapter 2
Installing Kofax Export Connector for
Pega Rules Process Commander
You can install this export connector on a Kofax Capture client workstation or standalone
workstation.
To install this export connector, you must have Windows administrator privileges. If you do
not have administrator privileges and install this export connector, you may receive error
messages and several of the files may not install correctly.
System Requirements
The server and client workstations used for this export connector must meet the system
requirements listed on the Kofax Web site. For information about supported operating
systems and other system requirements for this export connector, visit the Support pages on
the Kofax Web site at www.kofax.com .
Installing the Export Connector
1 If you have installed an earlier version of the import connector, uninstall it now.
2 Start the installation by running
Setup.msi
from the location where downloaded
it. If you are running the installation from removable media, the installation should
automatically start.
3 Follow the instructions on the screen to install the export connector.
4 When the installation is complete, a confirmation message appears.
Note Installing the export connector automatically registers it with Kofax Capture.
5 Repeat this procedure on all Administration and Export workstations that will use this
export connector.
Repairing the Export Connector
You can use the repair process to replace missing, renamed, or deleted export connector files.
1 Run the
.msi
file that you used to install the export connector.
When the existing installation is detected, the Application Maintenance window appears.
2 Select Repair, and then click Next.
3 Follow the on-screen instructions to repair the export connector.