Panasonic FV-08VKME3 - Manual (Page 9)

INSTALLATION I (JOIST MOUNTING -1) CONTINUED
6. Refer to wiring diagram. (Wiring detail please refer
to the wiring diagram on page 6.)
Follow all the local electrical safety codes as well as
the National Electrical Code (NEC).
Using UL approved wire nuts, connect house power
wires to ventilating fan wires. (Fig.4-1, Fig.4-2)
A
caution
O
Mount junction box cover carefully so that
lead wires are not pinched.
7. Finish ceiling work. Ceiling hole should be aligned
with the inside edge of the flange. (Fig.5)
IMPORTANT:
Remove the tapes from louver and springs
before installation. As shown below:
'Tapes«
FV-08VKME3 FV-08VKSE3
8. Insert the grille mounting spring on the wiring side
into the slot and insert the plug connector i into
the housing of the lighting unit. (Fig.6)
A
caution
O
O
Before turn on the light, make sure the
connector at the correct position. If not, the
lighting can't work.
The claw of connector must latch the rib
completely. (Fig.6)
9. Insert the sensor unit into slot of the grille.
Fix the sensor lead wire into the clasp
(1 position).(FV-08VKME3)(Fig.7)
Conduit^^V;
Junction box /
Ferrite Core
(For reducing the
electromagnetic noise)
Earth ground
to green
Wire nut
Neutral to white
Neutral to white
Live to blaci
(LIGhfT)
Live to black
(Ventilating fan)
FV-08VKME3
Fig.4-1
Conduit-
Junction box
Ferrite Core
(For reducing the
electromagnetic noise)
Earth ground
to green
Wire nut
Live to black
(Ventilating fan)
Neutral to white Two red wires_
Live to black (Connect to
(LIGHT) manual wall switch)
FV-08VKSE3
Fig.4-2
Ceiling Unit: inches (mm)
Tr
.1
After finishing the ceiling job, fill gap between flange
and ceiling with caulk or other sealant to prevent air
leakage. 5
Plug connector I
Mounting spring
Grille
LED Lighting unit
Lighting unit
Y
''insert
plug connector I Fig.6