Mongoose AMG 850 C - Manual (Page 5)

5
English
Emergency disarm.
If the control transmitter is missing or broken, to disarm the system: unlock the door
with a key an alarm mode will be started take your seat in the car and turn the ignition
on. With ignition on press the Override Switch as many times and the first digit of the
current PIN code, then turn the ignition off/on and press the Override Switch as many
times as the second digit of your PIN code. Turn the ignition off the system will disarm.
LED indication of system status
Armed blinks slowly
Disarmed out
Arming blinks fast
Valet mode continually lit
DIRECTIONS FOR USE .
Basic security features control
Arm.
To arm the system, press button 1 of the transmitter with ignition off. If the doors,
hood and trunk are closed, the siren will chirp once and the lights will flash once. The
system LED will blink slowly, the door locks will lock (if the car is equipped with lock
blocking actuators). If any door, hood or trunk happen to be open, three chirps and three
flashes will follow.
Arm status.
In the arm status the system monitors the state of all available pin switches of the
doors, hood and trunk, the status of ignition and the status of shock sensor, and also the
space disturbance and other sensors if installed. In addition, engine start is blocked in
this mode. If any guard zone is violated, a 30 second alarm mode is triggered.
Alarm.
Once the alarm mode is started, the siren will chirp and the signal lights will flash for
30 seconds or until cancelled using button 1 of the transmitter.
If the warning zone of shock sensor or the external zone of an additional sensor is
violated, the siren will issue a warning chirp.
Disarm.
To disarm the system, push button 1 of the transmitter, the siren will chirp twice and
the lights will flash twice. The LED will go out, the door locks will unlock (if the car is
equipped with lock blocking actuators). If an alarm mode has been started within the
armed period, there will be four chirps and four flashes at disarm.
If you opted for the Two step door unlock scheme at set up, the first push of the
button will open only the driver’s door, to unlock the other doors press button 1 again
and hold it for 3 seconds.