Acronova DQ-5610 Series User Manual
Page 14
Operation Manual, DupliQ DQ-5610
Version 2.0
14
© 2010, Acronova Technology, Inc.
B
EFORE
G
ETTING
S
TARTED
Tips for Handling Optical Discs
Never touch the printable or data surface of the disc,
as it may decrease quality and disc lifespan. Refer
to the arrows on the illustration to the right, Always
handle discs from the outer edge or the center hole.
What You Need to Start a Disc Publishing Session
The DupliQ is a PC-connected auto-recorder, which requires a USB
connection to a host computer. You will need a computer with the
minimum system requirements and compatible software to start a disc
publishing session.
Turning DupliQ On
Make sure that DupliQ’s device driver has been successfully installed
as previously explained.
Follow the steps below to get your DupliQ ready:
1) Connect the power cord to DupliQ and a wall outlet.
2) Turn DupliQ’s power switch to the On position.
3) Connect the USB cable to both DupliQ and your PC.
DupliQ will enter the initialization process and will remove any discs
inside the optical recorder. Be patient until the initialization process
has completed.
When initialization is complete, you will see the LED indicator light up
signaling that DupliQ is ready for a disc operation
Turning DupliQ Off
To turn DupliQ off, turn the power switch to the Off position. In case
there is a session underway, abort or wait until it has completed.
Although it is fine to leave the power cord plugged in, it is
recommended that you unplug the cord for increased safety when
DupliQ is not used for extended periods of time.