Acura 2001 Integra Sedan - Owner's Manual - Manual (Page 178)

Cooling System
5. Remove the reserve tank from its
holder by pulling it straight up.
Drain the coolant, then put the
tank back in its holder.
6. When the coolant stops draining,
tighten the drain plug at the
bottom of the radiator. Put a new
washer on the drain bolt, then
reinstall the drain bolt in the
engine block. Tighten it securely.
Tightening torque:
58 Ibf.ft (78 N.m , 8.0 kgf.m)
7. Pour Honda All Season
Antifreeze/Coolant Type 2 into
the radiator up to the base of the
filler neck. This coolant is a
mixture of 50 percent antifreeze
and 50 percent water. Pre-mixing
is not required.
The cooling system capacity is:
With 5-speed manual transmission:
(LS, GS)
1.16 US gal (4.4 ,0.97 Imp gal)
(GS-R)
1.24 US gal (4.7 ,1.03 Imp gal)
With automatic transmission:
1.24 US gal (4.7 ,1.03 Imp gal)
8. Start the engine and let it run for
about 30 seconds. Then turn off
the engine.
CONTINUED
Maintenance
RESERVE TANK
HOLDER
FILLER NECK
Fill up to here
RESERVE
TANK CAP
Main Menu Table of Contents