AERCO AERClean - Manual (Page 6)

Page 6
Benchmark Low NOx Series
AERClean Filtration System Instructions
Doc#
TID-0001-0A
Created: 10/13/2010 Revised: 11/11/2010 Owner: BS-Manager_V.D. DOC#: TID-0001-0A
Filter Selection Options
The available 16 x 20 panel filters consist of two types of metal reusable filters (which can be
cleaned and then reused) and two disposable pleated panel filters.
The metal filters are specified for use where large debris may be encountered such a leaves and
small airborne construction materials like insulation. There are two types of metal filters; one
made from aluminum and the second made from Stainless Steel (for locations where intake air
might contain elements that could corrode aluminum, such as “salty air” near the shoreline).
The disposable pleated filters are used for filtering out fine dust, like gypsum dust or fine saw-
dust and are disposable and replaceable and cost less than the permanent metal filters. A hybrid
version of both pleated and metal can be created by installing the 1” metal filter on top of the 1”
pleated filter. This allows for cleaning the top metal filter and replacing the bottom pleated filter
only when it becomes clogged with fine dust to the point where replacement is necessary.
If the type of environment is uncertain, it is recommended that the disposable 2” pleated filter (P/N
87002) be used and replaced when it becomes clogged with dust and debris. The filter housing
assembly is capable of using either 1” filters or 2” filters. Table 1, below, summarizes the filter
selection.
Environment Filter Options
Small airborne construction
materials (e.g. insulation); other
larger construction debris.
Fine dust (gypsum dust, sawdust,
etc.)
Uncertain environment type
P/N 87004
16” x 20” x 1” Aluminum
P/N 87003
16” x 20” x 1” Pleated
Notes
Re-usable.
P/N 87005
16” x 20” x 1” Stainless Steel
P/N 87002
16” x 20” x 2” Pleated
P/N 87003
16” x 20” x 1” Pleated
P/N 87004
16” x 20” x 1” Aluminum
Installed on top of:
P/N 87005
16” x 20” x 1” Stainless Steel
Installed on top of:
P/N 87002
16” x 20” x 2” Pleated
P/N 87002
16” x 20” x 2” Pleated
P/N 87003
16” x 20” x 1” Pleated
P/N 87003
16” x 20” x 1” Pleated
Re-usable, Suitable in corrosive en-
vironment (“salty” air).
Low cost, Disposable, longer re-
placement interval than 1”.
Low cost, Disposable, longer re-
placement interval than 1”.
Low cost, Disposable, longer re-
placement interval than 1”.
Extends replacement interval of 1”.
Extends replacement interval of 1”.
Top aluminum filter is reusable.
Top stainless steel filter is reusable
and suitable in corrosive environ-
ment (“salty” air).
Note: DO NOT use 87004 by
itself in these environments.
Note: DO NOT use 87005 by itself
in these environments.
Low cost,
Disposable.
Low cost,
Disposable.
TABLE 1 - Filter Selection
87004 1” Alum.
Filter on Top
87005 1” S.S.
Filter on Top
87003 1” Pleated
Filter on Bottom
87003 1” Pleated
Filter on Bottom