Canon VB150 - Manual (Page 8)

Dc In 13V
In Out 100/10BT
CC1
RS232C Video In
Ethernet
CC2 V1 V2 V3 V4
Slot-A
Slot-B
1 2 2 1
A B A B
+ -
External
device
output
LAN
cable
Ethernet
RS-232C
cable
Video cable
(RCA)
Camera
VB150
Ethernet
Motion
detected
Warning device
VC-C4R
Power
supply
unit
Wa
rning de
vice
ON/OFF
Camer
a control and
video images
Connector Attached Cable
Warning device via the power supply unit Out1
Video cable for the VC-C4R camera V1
Control cable for the VC-C4R camera CC1
Using the Motion Detection Function with a Predetermined Schedule
In this monitoring system, a warning tone is emitted when someone enters through the door and
the VC-C4R camera mounted on the ceiling captures a still picture. The figure below shows the
equipment that is installed and connected to the rear panel on the VB150.
Sample application in combination with a warning device
By running the motion detection function according to a schedule, you can construct a monitoring system
that records pictures in accordance with a preset schedule and that operates in response to variations in
the video image from the area covered by the camera. The recorded pictures are stored on a flash memory
card inserted into the VB150. ( → VB150 User's Manual P.80)
Installation Example
When the camera shooting the area
inside the door detects a change, an
ON event occurs.
In response to that event, a warning
tone is issued by the Out1 control, the
camera shoots a picture of the
entrance and the pictures are stored
on a flash memory card.
VB150 Connection Example
5
a
Warning
● Do not directly connect the power cord for
the warning device to OUT1 or OUT2.
● Please also refer to page 102 of the VB150
User's Manual.