AltiGen MAXCS 7.5 Polycom Configuration Guide - Manual (Page 17)

Polycom Configuration Guide Page 17 of 24
Configure Line Park
The Line Park feature is a kind of call park method. You can configure line park spots for a user to park calls on the
Polycom phone.
1. In MAXCS Administrator, set up Line Park groups (select PBX > Line Park Configuration). For detailed
instructions, refer to the MAXCS Administration Manual.
2.
Select PBX > AltiGen IP Phone Configuration. Switch to the Polycom tab. Select the extension.
The page shows you ten customizable sets of fields; each one is a lamp slot. You can configure a BLF slot
or a Line Park slot for each of the ten sets of fields.
3. In any available lamp slot (1-10), select Line Park from an open slot’s pull-down menu.
Figure 25: Example of a Polycom phone display showing Line Park slots LP13 and LP14
Figure 26: Configure Line Park Groups