Casio KL-7000 - Manual (Page 11)

10
To replace the memory back-up battery
Before using the Label Printer for the first time, be sure that you first use the following
procedure to install the memory back-up battery that comes with it. Data stored in memory
will be lost if you do not load this battery.
1. Switch power off.
2. Use a small phillips head screwdriver to loosen the screw that
secures the back-up battery compartment cover in place, and
remove the cover.
3. Wipe off the surfaces of a CR2032 battery with a soft dry cloth,
and install it with its plus (+) side facing up (so you can see it).
4. Carefully replace the battery compartment cover and secure it
in place with the screw.
• You should use the above procedure to replace the memory back-up battery once a
year.
To replace the main batteries
1. Switch power off.
• If you are using the AC adaptor to power the unit, you should also unplug the adaptor
from the Label Printer.
2. Open the battery compartment cover on the
back of the Label Printer by sliding it in the
direction indicated by the arrow.
3. Remove all eight of the old batteries.
4. Load a set of eight new batteries into the bat-
tery compartment, making sure that their posi-
tive (+) and negative (–) ends are facing in the
correct directions.
5. Replace the battery compartment cover.