AvMap APRS - Manual (Page 33)

Set-up for Kenwood TH-D7 A/E
with the AvMap Geosat 6 APRS
NOTE: These instructions assume you have basic familiarity with
operation of both the TH-D7 A/E and the AvMap Geosat 6 APRS .
a. While programming the Kenwood TH-D7 and/or
the AvMap Geosat 6 APRS, the communication cable
should be disconnected. Strange and/or bad things
can occur if you fail to heed this warning!
b. Starting with the Kenwood TH-D7. Note: Items in [
] are buttons and { } are items you enter and/or ‘see’
on the radio screen.
c. Push the [Power] button to turn the radio on.
d. Make sure that {T} and {CT} do not appear at the
top of your D7A screen, if they do press the [F] button
then [BAL] button to turn [T] off or the [F] button
then [POS] button to turn off [CT].
e. Press the [MENU] button and use the [Control Pad]
(the top or bottom of the large round key pad on
the left middle side of the D7A) to get to the APRS
setup menu {APRS 2-X} (the X here can be any letter
or number) and press the [OK] button (the right side
of the [Control Pad]) to select/enter. Then use the
[Control Pad] again to choose the APRS screen you
desire and press [OK] to select/enter.
f. Press the [ESC] button twice to leave the APRS
setup screen and return the D7A user screen.
g. You can now power down the radio and it will keep
your settings.
APRS functions
AvMap - 33