Awntech DESTIN - Manual (Page 24)

24
INSTALLING THE BREEZE SUPPORT LEGS (OPTIONAL AND CAN BE PURCHASED
SEPERATELY)
WARNING: BREEZE SUPPORTS ARE NOT DESIGNED TO MAKE RETRACTABLE AWNINGS A PERMANENT
STRUCTURE
• On the bottom track of the front bar there is a nut and washer next to each arm bracket.
• Remove the nuts and washers, insert the bolts into the holes in the L-shaped bracket on each leg
support. Re-install the washers and nuts. Tighten the nuts.
• If your patio is concrete: using a 3/8” shank-1/2” masonry bit, drill (2) 1-1/2” holes into your patio at
the spot that the legs are plumb when the awning is fully projected (You will need a level for this).
Insert (2) ¼” machine screw anchors into the hole, place the bottom bracket over it and screw the
thumb screw down until the anchor does not move. Once secure you can remove the thumb screw at
will without loosening the anchor.
• If your patio is wood: Using a 5/16” wood bit, drill (2) 2” holes into your patio at the spot that the legs
are plumb when the awning is fully projected. Install (2) ¼” tee-nuts into the hole and hammer them
flush with the surface. Install (2) ¼”x1” thumb screws through a ¼” washer, the leg bracket and into the
tee-nut.
• Adjust the height control nut on the legs to the desired length, and tighten.