Awntech DESTIN - Manual (Page 26)

26
REPLACING AWNING FABRIC
• If you have a motor, turn it off.
• Manually crank the awning out to full projection
• Remove the front bar end caps
• Using the provided Allen wrench, unloosen the bullets at each end of the front bar C channel.
• Ask your helper to get on a step ladder about five feet from the wall on the non-motor/non-crank side
of the awning.
• On a ladder mildly push the front bar toward the wall. This will loosen the fabric
• Remove the fabric by pulling it straight out the C-channel on the non-crank/motor side of the awning.
You should pull out the front and back simultaneously.
• Install the new fabric by sliding the ends back into the C-channel from the same side. You may need to
push the front bar slightly toward the wall while two helpers feed the beads into the C-channel. There
is a slot in the end of the roller eye for it to slide into.
• Reinstall both bullets and tighten the Allen screws.
• Re-install the front end caps
• Retract the awning manually.
• Turn on the motor.
REPLACING THE VALANCE
• Remove the right and left front end caps (I)
• Using the provided Allen wrench, unloosen all the bullets at the ends of the fabric.
• Remove the bullets from the C-channel.
• Remove the valance by pulling on it from the right side.
• Reinstall the new valance by sliding the top bead into the same slots in the front bar (J)
• Reinstall both bullets and tighten the Allen screws.
• Reinstall the right and left front end caps (I)