Blinds Chalet Privacy 1 Mini Blinds - Manual (Page 5)

5
INSTALLATION INSTRUCTIONS
Step 1. Check Package Contents
Missing part? Call 800-264-1190
Mounting hardware kit includes the following:
Part Quantity
a mounting bracket 2
b center support 0 (blinds up to 48” wide)
1 (blinds 49” to 72” wide)
c 1 1 /
8
” screws 4 per bracket
d hold down bracket 2
e ½” screws 4 (for hold down brackets)
f valance 1
g valance slats 2
h valance clips 2 (blinds up to 36” wide)
3 (blinds 37” to 62” wide)
4 (blinds 63” to 72” wide)
Note: one extra screw of each noted size is included for convenience
Step 2. Tools Required
Screwdriver, tape measure, pencil, drill, step ladder, scissor
Note: use #6 plastic anchors for dry wall or plaster mounting.
Step 3. Bracket Location and Installation
Your blind may be installed either inside the window frame or
outside the window frame.
For Outside Mounting:
Place a bracket on both ends of the head rail
Hold the blind level at the height desired and center it over the
window opening - mark the exact location of each bracket with a
pencil
Remove the brackets from the head rail and position each bracket
at the marked location and screw each bracket into the wall or
window molding using the 1
1 /
8
” screws, predrill the screw holes
using a 5/64" drill bit.
Center support: required for larger blinds
The top of the center support must be even with the top of the end
brackets
Screw into place approximately midway between the end brackets
– make sure that the center support does not interfere with the lift
cords or ladder cords of the blind.
Aluminum
PrivacyBlind