Blinds Chalet Privacy 1 Mini Blinds - Manual (Page 6)

6
Outside Mounting - Inside Mounting
For Inside Mounting:
Place a bracket on both ends of the head rail
Hold the blind in place and make a pencil mark at the rear of each
bracket where it contacts the inside of the window frame. Remove
the brackets from the head rail and align them with the marks.
Attach each bracket using the 1
1 /
8
” screws, predrill the screw holes
using a 5/64" drill bit.
Center support: required for larger blinds
Outside Mounting - Inside Mounting
Screw into place approximately midway between the end brackets
– make sure that the center support does not interfere with the lift
cords or ladder cords of the blind.
Step 4. Securing the Head Rail
Note: install the valance clips before securing the head rail (see step 5)
Lift the head rail into position – make sure it is properly seated in
the brackets and center support.
Close the hinged doors of the end brackets
Step 5. Valance Installation
Place the valance clips on the head rail.
Slide the valance slats into the valance.
Align the top of the valance with the top of the clips – press the
valance inward until it snaps into the lower portion of the clips.
Step 6. How to Operate the Privacy Blind
Please review the following operating instructions to insure the
proper performance of the privacy blind.
Always rotate the slats to the “open” horizontal position before
raising or lowering. This assures smooth operation and increases
the life of the blind.