Blinds Chalet Elite Cordless 1 Mini Blinds - Manual (Page 3)

3
One
Touch
Aluminum
Blind
INSTALLATION INSTRUCTIONS
Step 1. Check Package Contents
Missing part? Call 800-264-1190
Mounting hardware kit includes the following:
Part Quantity
a Mounting Bracket 2 (shades up to 36” wide)
3 (shades 36” to 54” wide)
4 (shades 54” to 72” wide)
b 1 1 /
8
” Screws 2 per bracket
[Note: one extra screw of each noted size is included for convenience]
Step 2. Tools Required
Screwdriver, tape measure, pencil, drill, step ladder, scissor.
Note: use #6 plastic anchors for dry wall or plaster mounting.
Step 3. Bracket Location and Installation
Your blind may be installed either inside the window frame or
outside the window frame.
A mounting bracket should be positioned about 1” to 3” from
each end of the head rail. For wider shades that require 3 or
more brackets, these should be spaced evenly between the two
outermost brackets. Always position the brackets such that there
is no interference with the mechanisms inside the head rail. The
procedure outlined below will assure proper bracket placement.
For Outside Mounting:
Clip the brackets onto the head rail as described above. Hold the
blind level at the height desired and center it over the window
opening. Mark the exact location of each bracket with a pencil.
Remove the brackets from the head rail and position the top of
each bracket at the marked location and screw each bracket into
the wall or window molding using the 11/8” screws, pre-drill the
screw holes using a 5/64" drill bit.