Blinds Chalet Elite Cordless 1 Mini Blinds - Manual (Page 4)

4
For Inside Mounting:
Clip the brackets onto the head rail as described above. Hold
the blind in place and make a pencil mark at the rear of each
bracket where it contacts the inside of the window frame.
Remove the brackets from the head rail and align them with the
marks. Attach each bracket using the 11/8” screws, pre-drill the
screw holes using a 5/64" drill bit.
Step 4. Securing the Head Rail
Lift the head rail into position such that the front edge of each
bracket is under the inner front edge of the head rail. Push the head
rail upward until the flexible tab at the bottom of each bracket snaps
onto the back of the head rail. Check carefully to assure that each
bracket is properly secured.
Step 5. Attach Handle / How to Operate
Attach the handle to the bottom rail as illustrated.
Always rotate the slats to the “open” horizontal position before
raising or lowering. This assures smooth operation and increases
the life of the blind.
To lower blind: Grip the Bottom-Rail/Handle and slowly pull
straight down.
To raise blind: Put one hand under the Bottom Rail (palm facing
up) and lift with a slow steady tempo until the
desired height is reached.
To tilt the slats: Lower and raise the handle slowly. This is a
learned technique, but takes only a few seconds
to master
CLEANING YOUR BLINDS
Dusting: use a soft cloth, feather duster, cylindrical dust brushes
specifically designed for blinds or vacuum using the soft brush