Blinds Chalet Honolua Woven Wood Shades - Manual (Page 6)

6
For Inside Mounting:
Place a bracket on both ends of the head rail.
Hold the shade in place and make a pencil mark at the rear of each
bracket where it contacts the inside of the window frame. Remove
the brackets from the head rail and align them with the marks.
Attach each bracket using the 1¼” screws.
Step 4. Securing the Head Rail
Lift the head rail into position – place a washer and wing nut on the
post of each bracket – tighten by hand.
Step 5. How to Operate
To lower shade: move cord to the left while pulling down gently until
cord lock releases – allow cord to slip through fingers until shade
reaches desired level – move pull cord to the right and release –
shade will lock automatically. To raise blind: pull cord downward
slowly until shade reaches desired height – release cord and
shade locks automatically. Make sure the cord stops are properly
positioned – see step 6 below
Step 6. Adjustment of Safety Cord Stops and Cord Length
To shorten the lift cords, mark the cords at the desired height. Slide
the tassels above this point, tie a new knot in each cord, and then
cut off the excess cord.
BE CERTAIN TO ADJUST THE SAFETY CORD STOPS AS
DESCRIBED BELOW. REDUCE RISK OF STRANGULATION TO
INFANTS AND TODDLERS. POSITION SAFETY CORD STOPS
BEFORE USING SHADES.
Lower shade to maximum desired length and lock into place.
Measure the distance from head rail to cord stops. If cord stops are
1 to 2" below the head rail, no further adjustment is needed. If not,
loosen but do not untie the knot surrounding the cord stop. Move
the cord stop as close to the head rail as possible and tighten knot
by pulling firmly on tassel. Repeat process for each lift cord.
WARNING
6” or less
Inner cords can pull out to form a loop,
which can strangle a young child.
• Inner cord stop devices can reduce
this risk if positioned correctly on the
pull cords.
• If inner cord stop devices are more
than 6 inches (153mm) below the
headrail when the blind is fully
lowered, move them closer by
following the inner cord stop device
adjustment instructions.