Boekel Scientific 132000-2 Economy Analog Incubators - Manual (Page 4)

3
2. Product Information
The Boekel series of Incubators are designed for laboratories and clinics that
require contemporary styling, accuracy and economy in a basic incubator package.
Boekel’s 132000 Incubator provides excellent incubator performance at the most
economical cost. This Incubator uses a dial controlled thermostat for temperature
control and provides a top enter ferrule entry point for thermometer insertion. The
132000 incubator has a chamber volume of 0.8 cu. ft. (0.02 cu. m) and a chamber
temperature range of ambient +5
˚C to 60˚C. The incubator comes with two
movable shelves. Additional shelving may be purchased.
3. Assembly
3.1 Unpacking
Remove packing materials carefully, and retain for future shipment or storage of
the unit. Inspect for damage. Report all shipping damage to the carrier
immediately. Shipping damage is covered by the carrier and repair/replacement
for shipping damages must be coordinated through the carrier. Complete and
return the Warranty Registration Card. Pack should contain:
• 132000 Incubator
• Operating Instructions
• Two Shelves
• Eight Shelf Brackets
3.2 Installation
Place the Incubator on a flat and stable surface, preferably away from drafts.
Insure that the surface on which the unit is placed will withstand the radiated heat
produced by typical laboratory incubators. Plug power cord into a power supply
that matches the voltage listed on the serial number label on the rear of the unit.
Insert the wire rack shelves at the desired heights. Refer to the sketch below for
proper shelf bracket installation for the Incubator.