Carl Goldberg GBGA1083 - Manual (Page 14)

14
Wild Stick .40
2. install the servos using the hard-
ware supplied with the radio. Use the
stings installed in the wing to pull
the wires through to the center of
the wing.
3. hinge the ailerons using the same
method used on the elevators. Center
all hinges and use thin CA to glue in
place making sure you have full
deflection in both directions and a
tight hinge line.
4. Use a straight edge to mark the
location of the four aileron horns in
line with the output arm. install the
four horns using the 2mm bolts and
nylon plates. Align over the hinge
line as we did on the elevators.