Carl Goldberg GBGA1083 - Manual (Page 18)

18
Wild Stick .40
19. Install the pushrod in the fuse-
lage guiding the rods out each side of
the fuselage in the slots provided.
20. Connect the clevis to the horn on
both sides with the silicone keeper
installed.
18. Install the 6” piece of wire on the
other end of the dowel and glue in
place. Install the heat shrink tube.
21. Center the servo arm, make sure
the elevators are centered and mark
the wire on the control arm. Bend 90
degrees and cut at 3/8”. Install in
servo arm and retain with nylon
swing in keeper.
Fuel Tank
1. Locate the fuel tank and hard-
ware.
2. Assemble the tank cap with the big
washer, the rubber stopper, and the
little washer in the rear. For a two
line system we will only use the long
piece of aluminum tube and one short
one.
3.Insert the tubes through the stop-
per and attach the silicone tubing on
the short one. Cut the tubing so that
when the clunk is attached it will be
about 1/4” off the bottom of the
tank when held vertically. Leave the
tubes out the front of the cap about
3/4” and bend the long tube at a 45
degree angle so it goes to the top of
the tank when installed.