Using rinse and spin, What happens in each cycie – Whirlpool RAM4132B User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
O P E R A T I N G Y O U R W A S H E R
Using rinse and spin
When using extra detergent for heavily soiled
clothes, or washing special-care items, you
may want an extra rinse and spin.
1. Push Cycle Control Knob in and turn clock
wise to one of the dots on the dial, as
illustrated.
2. Pull Cycle Control Knob out. The washer
will fill to selected load size, agitate, drain,
and spin.
What happens in each cycie
When the Cycle Control Knob is set to a
number and pulled out, the washer fills to the
selected water level with the selected water
temperature before agitation and timing start.
The washer will begin agitating immediately
after filling; agitation can occur with the washer
lid up or down. After agitation starts, the knob
turns clockwise until it points to OFF and the
cycle ends.
The washer pauses briefly throughout
each cycle. These pauses are normal for
washer operation.
NOTE: If your washer drains into a laundry
tub, remove lint collected in the tub or strainer.
Fill
Wash selected time
Drain-No agitation
îB?
Spin
ffî.....
Fill
Rinse
Drain-No agitation
Spin
A
Off