To clean, Pre-wash cycle, Manual clean lint filter – Whirlpool LT5004XV User Manual
Page 12
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
other Operating Instructions
Continued
Pre-wash Cycle
For best results, use warm water for
pre-washing stained laundry. Hot water
can set stains.
1. Use recommended amount of
pre-soak product or detergent.
2. Push Cycle Control Knob in.
3. Turn clockwise to point to the
number next to PRE-WASH.
4. Pull the Cycle Control Knob out. The
washer will start.
5. When the cycle is over, add
detergent for the next selected wash
cycle. The PRE-WASH Cycle should
always be followed by a wash cycle.
NOTE:
See the Laundry Guide for
additional pre-washing information.
Agitator
barrel
Manual clean lint filter
Clean the filter at the bottom of the
agitator after every load for the best
filtering results.
NOTE:
The load type will vary the
amount of lint build-up.
To clean:
1. Lift off the agitator barrel.
2. Wash or wipe the filter clean in the
bottom of the agitator barrel. The
filter is not removable.
3. Replace the agitator barrel and snap
it into place.
12