Whirlpool LT5004XV - Manual (Page 17)

Heat element terminals
Electric dryer
3. ROLL lint off the screen with your
fingers. Do not rinse or wash the
screen.
4. Replace the cover on the body of the
lint screen.
5. Before replacing the lint screen, re­
move any lint from the wire mesh on
the back wall (behind the lint screen).
6. Push the lint screen straight back
until it snaps into place.
Clean lint from inside the dryer.
Lint can gather inside the dryer and
create a
FIRE HAZARD. This lint
should be removed at least every
2 to 3 years, or more often,
depending on dryer usage.
i^WARNING
Electrical Shock and
Personal Injury Hazard
• Unplug the power supply cord
or turn off the electrical power.
• Do not put hands inside the
cabinet.
• Make sure the dryer is cool.
• More than one person is
required to lift, tilt or move the
washer/dryer because of its
weight and size.
Failure to do so could result in
electrical shock, injury or
damage.
Gas dryer
Cleaning should be done only by a
qualified person.
1. Unplug unit from electrical supply or
turn off electrical power.
2. Remove back panel from dryer.
(See Installation Instructions.)
3. Avoid touching wires and thermostats.
4. Remove lint from boxed-in area with
a soft brush or vacuum cleaner.
5. Replace back panel, reconnect and
level the Thin Twin.®
17