Other operating instructions, Rinse and spin, Drain and spin – Whirlpool LT51OOXS User Manual
Page 11: Soak cycle, Rinse and spin drain and spin soak cycle
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
other Operating Instructions
Rinse and spin
You may need an extra rinse and spin
for heavily soiled loads which have had
extra detergent added for proper
cleaning.
1. Push Cycle Control Knob in.
2. Turn clockwise to any dot on the dial.
3. Pull Cycle Control Knob out. The
washer will fill to selected level, agi
tate 2 minutes, drain and spin.
Drain and spin
Your washer can be set to drain and
spin out water.
1. Push Cycle Control Knob in.
2. Turn clockwise to the bar just before
the OFF area in any cycle. See
drawing.
3. Pull Cycle Control Knob out. The
washer will drain and spin.
Soak cycle
For best results, use warm water for
soaking stained laundry. Hot water can
set stains.
1. Use recommended amount of
pre-soak product or detergent.
2. Push Cycle Control Knob in.
3. Turn clockwise to point to the
number next to SOAK.
4. Pull the Cycle Control Knob out.
The washer will start.
5. When the cycle is over, add
detergent for the next selected
wash cycle. The SOAK Cycle should
always be followed by a wash cycle.
NOTE:
See the Laundry Guide for
additional soaking information.
11