Fire hazard, Using fluff air, Using tumble press – Whirlpool LT51OOXS User Manual
Page 16: Lint removal, End-of-cycie signal, Cleaning the lint screen, Using fluff air using tumble press, End-of-cycle signal, Lintremoval, Warning
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
^WARNING
Fire Hazard
Do not dry heat-sensitive mate
rials with heat. Failure to follow
this precaution could result in
fire or damage.
Using FLUFF AIR
The dryer does not heat when the Tem
perature Selector is set on FLUFF AIR.
This setting can be used to fluff bed
ding, plastic tablecloths, foam rubber
pillows, stuffed toys, sneakers, etc.
Using TUMBLE PRESS®
The TUMBLE PRESS setting removes
wrinkles from clothing that has been
packed in a suitcase or closet, and from
items not removed from the dryer at the
end of a cycle.
Lint Removal
The load will tumble in heated air for
10 minutes. Then the dryer will tumble
the clothes for 5 more minutes without
heat.
For best results, put only a few items
at a time in this cycle. As soon as the
dryer stops, put the items on hangers or
fold them.
End-of-cycie signal
The dryer sounds a signal to let you
know when the cycle is finished. The
signal cannot be turned off and is not
adjustable.
The signal is helpful when you are
drying permanent press, synthetic and
other items that should be taken out as
soon as the dryer stops.
Cleaning the lint screen
^WARNING
Fire Hazard
Do not run the dryer with the lint
screen loose, damaged, blocked
or missing. Doing so can cause
overheating, damage fabrics and
be a FIRE HAZARD.
The lint screen is located inside the
dryer drum, on the back wall. Clean it
before each load. To clean:
1. Use the finger holes to pull the lint
screen straight out.
16