The water dispenser, The dispenser light, Using the automatic ice maker – Whirlpool 8ED27DQ User Manual

Page 14

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

The water dispenser

Chilled water comes from a tank behind the meat
drawer. It holds approximately Vh quarts (1.5 L).

When the refrigerator is first hooked up, press

the water dispenser bar with a glass or jar until
you have drawn and discarded 2 or 3 quarts (1.9
to 2.8 L). The water you draw and discard will

rinse the tank and pipes.

Allow several hours to chill a new tankful.

NOTE: The small tray beneath the dispenser is
designed to evaporate small spills. There is no
drain in this tray. Do not pour water into it.

To dispense water:
1
. Press a sturdy glass against the water

dispenser bar.

2. Remove the glass to stop dispensing.

NOTE: Dispense enough water every week to
maintain a fresh supply.

The dispenser light

To turn on night light, slide dispenser LIGHT
switch to the left. See page 17 for directions for
changing the dispenser light bulb.

O D

Using the automatic ice maker

Here are a few things you will want to know about

your automatic ice maker:
• The ON/OFF lever is a wire signal arm.

Down ... to make ice automatically.
Up ... to shut off the ice maker.

NOTE: Do not turn ice maker on until it is
connected to the water supply. Instructions for
ice maker water supoiv hook up are attach­
ed to the back of the refrigerator cabinet.
It is normal for ice crescents to be attached by a
corner. They will break apart easily.
The ice maker will not operate until the freezer
is cold enough to make Ice. This can take
overnight.

If ice is not being made fast enough and more
ice is needed, turn the Refrigerator Control

toward a higher number. Wait a day and, if
necessary, turn the Freezer Control toward C.
Good water quality is important for good ice
quality. It is not recommended that the ice
maker be connected to a softened water supply.
Water softener chemicals, such as salt from a
malfunctioning softener, can damage the ice
maker mold and lead to poor Ice quality. If a
softened water supply cannot be avoided, it is
important that the water softener be well
maintained and operating properly.

Raise

signal

arm to

stop ice

maker.

Lower

signal

arm to

start ice

maker.

13

Advertising