For rinsing oniy for spinning oniy, Water levels and load sizes – Whirlpool 3LA5800XK User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
For Rinsing Oniy For Spinning Oniy
Your washer can be set to rinse
only. Use the setting for an extra rinse,
or for laundn/ that only needs a rinse
and spin.
There is a dot just after the num
bers in PERMANENT PRESS, REGULAR
HEAVY and KNITS GENTLE. If you push
in on the Cycle Control Knob, turn
the pointer to one of those dots and
pull the Control Knob out, the washer
will fill, agitate, drain and spin
If you want high agitation and
spin, use the dot in REGULAR HEAVY. If
you want low agitation and spin, use
the dot in KNITS GENTLE, Use the dot in
PERMANENT PRESS if you want high
agitation and a low-speed spin.
There may be times when you
want to drain out all the wash water
and start over. To stop the washer at
any time, just push in on the Cycle
Control Knob
To set the washer so it drains
and spins water out of the load, push
in on the Control Knob, turn the dial to
the right (clockwise) so the pointer is
touching the bar just before OFF in
any cycle.
The washer will dram, spin out
water and stop. If you want a low-
speed spin, use the bar on PERMA
NENT PRESS or KNITS GENTLE, All the
other cycle settings have a high-speed
spin
regular
heavy
permanent
Water Levels and
Load Sizes
The LOAD SIZE SELECTOR lets
you control the amount of water that fills
the washer. The selector can be set at
any water level between HANDWASH-
ABLE and EXTRA LARGE.
WATER LEVELS
Setting
HANDWASHABLE
MEDIUM
EXTRA LARGE
Gallons/Liters*
7.8/29.5
13.9/52.6
20,5/77,6
* Approximate fill with load.
To change the water level setting,
move the LOAD SIZE SELECTOR to
RESET. Then move it to the setting you
want To save water and energy,
match the water level to the load
For the best cleaning results, the
load should move freely in the water.
Watch for rollover. An item (like a sock)
should sink in the middle and come
up later on the outside.
Be sure to read pages 11 -13 in
your Laundry Guide. You will find more
information on loading and load sizes.
IMPORTANT:
• The HANDWASHABLE setting is
designed for very small loads. It
uses very little water. Too big a
load in this amount of water may
tear some items.
• Water may splash if you use
very low water levels with REG/
HEAVY. If this happens, move the
LOAD SIZE SELECTOR to RESET. Then
move it to a higher setting.