Whirlpool Roper RAB4232DL0 - Manual (Page 7)

O P E R A T I N G Y O U R W A S H E R
Using rinse and spin
When using extra detergent for heavily
soiled clothes, or washing special-care
hems, you may want an extra rinse and spin.
1. Push in Cycle Control Knob and turn
clockwise until indicator points to RINSE,
as illustrated.
2. Pull out Cycle Control Knob. The washer
fills to selected load size, aghates, drains,
and spins.
Using drain and spin
A drain and spin may help shorten drying
times for some heavy fabrics or special-care
hems by renwving excess water.
1. Push in Cycle Control Knob and turn
clockwise until indicator points to SPIN,
as illustrated.
2. Pull out Cycle Control Knob. The washer
drains and then spins.
What happens in each cycie
When the Cycle Control Knob is set to a
number and pulled out, the washer fills (to
the selected load size) before aghation and
timing start. The washer begins agitating
immediately after filling; aghation can occur
whh the washer lid up or down.
After aghation starts, the Cycle Control Knob
turns clockwise until h points to an OFF area
and the cycle ends.
The washer pauses briefly during the
Permanent Press cycle. These pauses are
normal for washer operation.
WASH RINSE
Fill Fill
L
jl
♦
Wash selected time
m
Rinse
Drain (or partial drain*)
No aghation
Drain-No aghation
‘The Permanent Press cycle partially
drains, fills, agitates brie^, and drains.
Spin
l#i Spin
IJJ
Off
7