Pull out cycle control knob to start washer, Stopping/restarting your washer, Selecting a cycle and time – Whirlpool 3366869 User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
O P E R A T I N G Y O U R W A S H E R
4. Push in the Cycle Control Knob and
turn it clockwise to the wash cycle
you want. See pages 7 and 8.
5. Pull out Cycle Control Knob to start
washer.
6. (OPTIONAL STEP) If desired, add mea
sured liquid chlorine bleach after the
washer starts agitating. See page 10.
7. (OPTIONAL STEP) If desired, add mea
sured and diluted liquid fabric softener
to the final rinse cycle. See page 10.
Stopping/restarting your washer
• To stop the washer at any time, push in
the Cycle Control Knob.
• To restart the washer, close the lid (if
necessary) and pull out the Cycle Control
Knob.
Selecting a cycle and time
Your washer’s Cycle Control Knob Is shown
below. Use the information in this section to
help you make the best cycle selections for
your wash loads. Each cycle Is designed for
different types of fabrics and soil levels.
• The washer pauses briefly throughout
each cycle. These pauses are normal
for washer operation.
• Refer to page 9 to learn more about the
sounds you may hear during a wash cycle.
• Also, refer to page 9 to help you under
stand what happens during a wash cycle.
PERMANENT
4 COLD PRESS
PULL START PUSH STOP
4 CYCLE 2 SPEED