Whirlpool LLC7244AN0 - Manual (Page 5)

OPERATING YOUR WASHER
Operating Ybur Washer
In This Section
Page Page
Before starting your washer.................. ........... 5 Selecting a cycle and time............. ....................7
Starting or stopping your washer........ ........... 5 Using rinse and spin....................... ................. 10
Selecting a load size.............................. ........... 6 Using drain and spin...................... .............. 10
Selecting wash-rinse temperatures .... ........... 6 What happens in each cycle.......... .............. 11
Selecting agitation-spin speeds........... ........... 7
Operating your washer properly assures maximum washing efficiency. This section gives you
important information to help you make selections for your wash loads.
Before starting your washer
Add measured detergent. Then place a sorted NOTE: If your washer has a Consumer Buy
load in the washer before starting. See page 14 Guide, remove it and place it in your Use and
for additional “Before you wash" information. Care Guide.
Starting or stopping your washer
starting your washer:
1. Push in the Cycle Control Knob and turn it
clockwise. Stop when the indicator on the
knob’s outer ring points to the number in the
wash cycle you want. The numbers are
minutes of wash time.
2. Select a load size, water temperature,
agitation and spin speeds.
3. Pull out the Cycle Control Knob.
Stopping and restarting your washer:
• To stop the washer at any time, push in the
Cycle Control Knob.
• To restart the washer, close the lid (if neces­
sary) and pull out the Cycle Control Knob.
Cycles may vary with model