Understanding what happens in each cycle, Wash, Manual clean lint filter – Whirlpool 3363560 User Manual
Page 10: To clean
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
OPERATING YOUR WASHER
Understanding what happens in each cycle
After agitation starts, the Cycle Controi Knob
turns clockwise until it points to an OFF area
and the cycie ends.
When the Cycle Control Knob is set to a
number and pulled out, the washer fills (to
the selected load size) before agitation and
timing start. The washer begins agitating
immediately after filling; agitation occurs with
the washer lid up or down.
NOTE: The washer pauses briefly through
out each cycle. These pauses are normal for
washer operation.
WASH
Fill
Wash selected time
Drain*
No agitation
*The Permanent Press cycle partially
drains, fills, agitates briefly, and drains.
Spin
RINSE
Fill
Rinse
Drain - No agitation
Spin-Spray rinse
Spin
A
Off
Manual clean lint filter
Your washer has a manual clean lint filter.
Clean the filter at the bottom of the agitator
after every load for the best filtering results.
To clean:
1. Lift off the agitator barrel.
2. Wash or wipe the filter clean in the
bottom of the agitator barrel. The filter is
not removable.
3. Replace the agitator barrel and snap it
into place.
Agitator barrel
Manual clean
lint filter
10