Whirlpool MCB790XT - Manual (Page 6)

Programming tone
Each time you touch a pad you will hear a tone. It you don't hear a tone, it is because the instruction
is not correct, or because the tones have been removed.
EXAMPLE: If you touch a Number Pad before you touch a Command Pad, you will not hear a tone.
The instruction is not correct.
If you want to remove the
programming tone and end
of cooking tone (beep
every 60 seconds whiie
“End” is dispiayed):
• Open the door.
• Touch CANCEL twice, then
touch START.
• The tone will not sound for
any touch.
If you want to replace the
programming tone and end
of cooking tone (beep
every 60 seconds while
“End” is dispiayed):
• Open the door.
• Touch CANCEL twice, then
touch START.
• The tone will sound for any
correct touch.
If you want to remove all
tones, except the minute
timer signal:
• Open the door.
• Touch CANCEL twice,
touch 0, then touch START.
• All audible tones will be
cancelled.
• To replace the tones,
repeat the above steps.
NOTE: If electric power ever goes off, the programming
tones will again sound each time you touch a pad.
Setting the clock
When the oven is first plugged in, a tone sounds and the display shows 888
:
88
.
If the electric power
ever goes off, the display will again show all 8's when the power oomes back on.
You can cook or use the Minute Timer without setting the clock, but the display will be blank
after cooking.
DO THIS... THIS HAPPENS...
1. Touch CLOCK SET.
\l/ _
. I I
■ u
/l\
The Display will show a "0" and
the colon will start to flash. The
first Number Pad must be touched
within 5 seconds or the Display will
go blank. Touch CLOCK SET again
and continue.
3
I
2
2. Touch Number Pads for fhe
correct time of day.
D - O C
____ f
/W
The Display will show what numbers
you touched in the order you
touched them. This example shows
3:25.
3. Touch START.
D - D C
J i ! _ _ _/
The colon will stop flashing. The Clock
is set.
If you have touched in an incorrect
time, such as12:65, “Err" will show on
the Display. Touch CLOCK SET and
start over.
NOTE: To reset the clock, touch CLOCK SET. The current time will show on the Display and the colon
will flash. Continue to set the clock as shown above.