Water requirements, Drain requirements, Now start – Whirlpool 3369088 User Manual
Page 3: With dishwasher in kitchen
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Water
requirements
The hot water lihe to the dishwasher
must provide betweeh 15 - 120 PSI
water pressure.
The hot water heater
should be set to deliver 140°F water
temperature to the dishwasher for
best resuils.
Use 3/8" O.D. copper tubing or 1/2"
plastic tubing minimum inlet line.
Dishwasher inlet valve has 3/6"
internal pipe thread.
Drain
requirements
Drain line connection to house
plumbing must be minimum 20"
above floor to prevent siphoning.
Drain hose, supplied, meets
AHAM DW-1 test standards. Cut
1-1/2" hole in cabinet wall for drain
hose. Additional drain line, a
minimum of 1/2" I.D. and no longer
than 20 feet can be used if needed.
Now start...
with dishwasher in kitchen.
Disconnect electric supply before
installing dishwasher.
1
Remove the
4
screws
■ attaching access panel and
toe panel to dishwasher using a 1/4 "
socket wrench or Phillips screwdriver.
Remove occess panel and toe
panel.
opening. Measure height of cabinet
opening from underside of
countertop to floor. Check chart for
that height opening, Put the wheels
in the required position,
Min.
Culout
Heighl
Wheel
Position
(See
lllustrotion)
Number
Of turns
To Preadjuil
Levelers
33-7/8"
1 ' 0
34-1/16"
2
3
34-1/4-
3
6
34-7/16'
4
9
For addiNonal height:
1. Add shims under the wheels.
2. Turn front levelers (each turn adds 1/16"
in height).
Loosen and then turn front levelers
the number of times indicoted in
the chart.
Numbers
Panel B