Starting your washer – Whirlpool LA98OOXP User Manual
Page 4
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Starting your washer
Before starting your washer:
1. Measure and add detergent.
2. Place sorted load in washer.
3. Start washer.
The automatic washer has Solid
State Electronic Controls. Read instruc
tions carefully before setting any
cycles.
Select a
1. LOAD SIZE
Move POWER /
2. SWITCH TO ON.
To change the setting on the
LOAD SIZE SELECTOR, move the tab
to RESET.
• Then move the tab to a setting that
describes the size of the load you
want to wash.
• Set the tab on or between HAND
WASHABLE (a few small items) and
EXTRA LARGE (a full load).
See the “Laundry Guide” for details
on load sizes.
The REG/HEAVY Indicator Light wil
come on. You will have 8 seconds
to touch a different FABRIC selector.
If you do not touch a different
FABRIC selector, the washer will
automatically start in the REG/
HEAVY cycle.
LOAD SIZES AND WATER LEVELS
For best cleaning results, the
load must be able to move freely
in the water. Too big a load or too
little water can cause wear or
tearing of load items.
’Approximate
fill with load.
o
DO NOT
OVERLOAD WASHER.
EXTRA LARGE (20.5 gals/77.6L)*
MEDIUM (13.9 gals/52.6L)*
HAND WASHABLE (7.8 gals/29.5L)^