Other operating instructions, For a rinse and spin, For a drain and spin – Whirlpool LA3800XM User Manual
Page 8: For a soak or pre-wash
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Other operating instructions
..r
" > U A K
For a rinse and spin
You may need an extra rinse and
spin for heavily soiled loads which
need more detergent. (Extra de
tergent can require an extra rinse.)
• Push Control Knob In.
• Turn clockwise to any on the dial.
See above drawing.
• Pull Control Knob out.
• The washer will fill with cold water,
agitate 2 minutes, drain and spin.
For a drain and spin
Your washer can be setto drain
and spin cutwater.
• Push Control knob in.
• Turn clockwise to the bar just before
OFF in any cycle. See above
drawing.
• Pull Control Knob out.
• The washer will drain and spin.
Water level and temperature
can't be adjusted in this setting.
For a soak or pre-wash
For best results, soak or pre-wash
heavily soiled or stained laundry.
• Use enough detergent or pre-soak
product for a single load.
• Push Control Knob in.
• Turn clockwise to point at a number
in the SOAK Oycle...use the 12-
minute mark for a pre-wash.
• Pull Oontrol Knobout.(Afterfilling,
the washer may pause befare
starting to agitate.)
• When the cycle is over, add de
tergent for the next selected wash
cycle Important: See additional
care information on page 7 of your
“Laundry Guide.”
• Set the washer and start the next
selected wash cycle.
To start the soak or pre-wash with agitation, the Cycle Control
Knob must point to a number in the SOAK Cycle.