Whirlpool LA980OXK - Manual (Page 5)

AVhirlpool
5 .
Indicator Lights.
• The light on each selector you touch
will glow to show that your selection is
recorded. They wd glow until the load Is
tinished
There is an
ndicator light on
every selector.
If an indicator does not glow after
selector is depressed:
- The eight-second selection
time ran out.
- The selector was not touched
on the lower half.
- The option selected can't be
combined with the FABRIC
Selection. See pages 8-13 for
details on each selection.
•
• hour Indicator Lights below the selec­
tors [SOAK SUPER WASH, WASH, RINSE
2nd RINSE and FINAL SPIN) go on and
off to let you know what the washer is
doing
• T,he light on the HOLD Selector glows
when you have stopped the washer
by touching HOLD
• The light on the RUN Selector goes off
only when the w-asher Is OFF, on HOLD,
or during the eight second selection
period.
6
.
Changing a selection.
• Before the washer starts, touch an­
other selector. That cancels the one you
don't want. See page 7 for details
• .After the washer starts, move the
switch to POWER OFF,
- Start back at Step 1
—
Or, if you w'ant to dram any water
before making new selections
1, Move switch to POWER ON
2 Touch SPIN ONLY,
3 Start at Step 1 when spinning
stops,
7 .
HOLD and RUN Selectors.
• Touch HOLD if you want to stop the
washer for any reason, but want to start
it again where it left off.
• Touch HOLD if you want more than
eight seconds to make selections
• Touch RUN to cancel HOLD
• Touch RUN to immediately start the
cycle
POWER FAILURE. If the electricity
goes off or a fuse blows while the
washer is running, all selections
are canceled. See instructions on
page 7.
To Stop the Washer:
- During spin...touch HOLD or lift
the lid.
-Any tinne...touch HOLD or
switch to POWER OFF,
SPIN ONLY cancels all selections
including HOLD.