2 connecting the classpad to another device, 2 connecting the classpad to another device -2-1, Connecting to another classpad unit -2-1 – Casio ClassPad 300 User Manual
Page 621: Connecting the classpad to another device
20021201
15-2-1
Connecting the ClassPad to Another Device
15-2 Connecting the ClassPad to Another
Device
This section provides detailed explanations about how to connect the ClassPad to another
ClassPad unit, to a computer, and to a CASIO Data Analyzer.
Connecting to Another ClassPad Unit
Use the procedure below to connect two ClassPad units.
k Required Hardware
ClassPad: 2 units
Special SB-62 Cable: 1
u ClassPad Operation
(1) Turn both units off.
(2) Remove the connector covers from the 3-pin ports of both units.
(3) Connect the data communication cable as shown in the illustration below.
• Insert both of the plugs securely, as far as they will go.
• For information about what you should do to transfer data, see “15-4 Transferring
Data to Another ClassPad Unit”.
Tip
• Be sure that you do not misplace or lose the connector covers.
• To protect against dirt, dust, and static electricity, be sure to replace the connector covers
whenever the cable is not connected.
Cable