Whirlpool 220-240~volt - Manual (Page 5)

Tools and materials needed for
installation:
Cable clip
Now start
With compactor in room where it will be installed.
Do not grasp console to move compactor.
Slide compactor onto cardboard or hardboard
before moving compactor across fioor to prevent
damaging floor covering.
Do not allow the rear frame of compactor to
touch the floor covering when iifting or moving
compactor.
1 ■ Remove compactor from shipping carton. Remove
all protective packaging materials such as tape and
shipping pads. Remove waxy residue caused by
protective shipping material with a mild solution of
liquid household cleaner and water.
2. Plug in power cord to compactor power inlet on the
back panel. Power cord may be attached to cable clip.
3. Place two corner posts from carton on floor near
compactor. Open compactor drawer and remove
any shipping materials or other items shipped in
the drawer. Do not remove the compactor bag
(if installed). Grasp the handle and raise the front of
the drawer until it clears stops. Grasp sides of drawer
and lift drawer out of compactor. Place the drawer on
the two corner posts.
IMPORTANT: Use proper lifting methods in order to
avoid injury.