Installation instructions continued, Adjusting the toe plate – Whirlpool 220-240~volt User Manual

Page 7

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Installation Instructions
Continued

9.Grasp sides of compactor drawer and place bottom

of drawer into tracks. Lift at the handle so the front
of drawer will go over drawer stops. Close drawer.

Check if drawer opens freely. If the toe plate rubs
against floor, see "Adjusting the toe plate” for further
instructions.

Adjusting the toe plate

If the toe plate rubs the floor covering, the toe plate

clearance may be changed as follows:

a.

Mark on each side of the toe plate the amount of toe

plate that rubs the floor covering.

b.

Remove the drawer from the unit. (See Step 3.)

c.

Use a rule and pencil or chalk to draw a line between

the marks on each side of toe plate.

d.

Use scissors to cut toe plate along line.

Replace drawer. (See Step 9.) If toe plate still rubs
floor covering, repeat steps a-e.

Advertising
This manual is related to the following products: