Other operating instructions, Rinse and spin, Drain and spin – Whirlpool LPR4231A User Manual
Page 11: Soak cycle
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
other Operating Instructions
Rinse and spin
When using extra detergent for heavily
soiled clothes, or washing special-care
items, you may want an extra rinse
and spin.
1. Push Cycle Control Knob in.
2. Turn clockwise to one of the dots
on the dial, as illustrated.
3. Pull Cycle Control Knob out. The
washer will fill to selected level,
agitate 2 minutes, drain and spin.
Drain and spin
A drain and spin may help shorten
drying times for some heavy fabrics or
special-care items by removing excess
water.
1. Push Cycle Control Knob in.
2. Turn clockwise until indicator points
to any bar just before an OFF area
on the dial, as illustrated.
3. Pull Cycle Control Knob out. The
washer will drain and spin.
Soak cycle
For best results, use warm water for
soaking stained laundry. Plot water can
set stains.
1. Use recommended amount of pre
soak product or detergent.
2. Push Cycle Control Knob in.
3. Turn clockwise to point to a number
next to SOAK.
4. Pull the Cycle Control Knob out.
The washer will start.
5. When the cycle is over, add
detergent for the next selected
wash cycle. The Soak cycle should
always be followed by a wash
cycle.
NOTE:
See the Laundry Guide for
additional soaking tips.
11