Whirlpool LT7004XV - Manual (Page 15)

The automatic cycles
The automatic cycles allow you to
select the degree of dryness you prefer
for the clothes being dried.
The electronic DRY-MISER® control
is an electronic sensor that determines
the amount of moisture in the clothes.
The dryer automatically shuts off when
the proper dryness is reached.
The Cycle Control Knob will not move
until the clothes load is almost dry, or
the Cool-Down portion of the cycle has
been reached. After the Cool-Down
portion is complete, the Cycle Control
Knob automatically moves to an OFF
area and tumbling stops.
Use AUTOMATIC REGULAR to dry
heavy and mediumweight cotton items.
The load tumbles without heat during
the last 8 minutes. This helps make the
load easier to handle.
Use AUTOMATIC PERMANENT
PRESS to dry permanent press, knits
and other synthetic items. The load
tumbles without heat during the last 13
minutes. This helps keep wrinkles from
setting in and makes the load easier
to handle.
TIMED DRYING 50
PERMANENT
PRESS
For the first few loads, set the Cycle
Control Knob to point to the * in either
automatic cycle. When the dryer stops,
feel the dried items.
• If items are drier than you like, use a
setting to the right of the * the next
time you dry a similar load.
• If items are not as dry as you like, use
a setting to the left of the * the next
time you dry a similar load.
NOTE; Overdrying can cause
shrinkage, static cling and damage to
some fabrics.
15