Whirlpool LA4400XS - Manual (Page 4)

Starting your washer
Before starting your washer:
1. Measure and add detergent.
2. Place sorted load in washer.
3. Start washer.
Select a
1. LOAD SIZE
Select CYCLE and
WATER TEMPERATURE;
2. Start the washer
• Turn the knob to point at a setting
that describes the size of ioad you
want to wash.
• Set the knob anywhere on or
between small (a few items) and
large (a full load).
NOTE: Use the LARGE water level
for best permanent press results.
A. Push in the Control Knob and
turn It to the right. It must be
pushed in and turned oniy
clockwise.
LOAD SIZES AND
WATER LEVELS
For best cieaning results, the
load must be able to move freely
in the water. Too big a load or too
little water can cause wear or
tearing of load items.
CAUTION:
B. To select wash water temperature,
DO NOT stop on the area in the selected
OVERLOAD WASHER. cycle marked H (hot), W (warm)
or C (cold).
• 1 LARGE Match the wash water tem­
M (17.2gals./65.1L)* perature to the type of fabrics
\ ; I SMALL
and soils being washed.
(9.5 gals./36.0 L)*
Recommended wash tem­
peratures can be found in your
'Approximate
fill with load.
“Laundry Guide.”
All rinses are cold. Cold rinses
save energy and help prevent
wrinkles from setting into fabrics.